Loepfe Savio FRS 3000, Инструкция по установке

Страница: 19 / 30

19
3N1
SYSTEM SETUP
System Setup
Start Up
The functioning of the complete system has to be checked in any case.
After completing the installation and safety checks for the Savio machine, power on the machine and both machine sides.
1. The SCU starts up.

If not, check the SCU power connection.
2. Within one minute, the LEDs of the SH of at least the first section show a blinking light.
Settings
Caution:
Touch the touch screen with bare finders only. Do not use any object or tool to touch the screen. Do not push hard on
the screen, nor hit it with a heavy or sharp object. Remove the protection foil of the SCU display (touch screen).
Next table lists the settings to be done. Enter the system or user password when it is requested. The system password is known
by Savio and Loepfe installers only. The default user password is “123”. Save settings by pressing OK or
.
Setting Where? Do what?
Date and
Time Setup menu > System
Date / Time
Select the current date, set current time and select the time zone.
Number
of spindles
Service
menu >
Machine
Configuration
>
Side(s)
Enter the number of spinning units of each machine side.
Note:
After saving the settings, the picture in the
Machine Overview
page is adapted.
Number
of piecers Service menu > Machine
Configuration > Side(s)
Enter the mumber of piecers.
Note: 3N1 can generate Q-reports per piecer.
Note:
Other configuration settings are set in accordance with or by the customer.