3 - Setup instructions GE MAC 1200ST
3 - Setup instructions GE MAC 1200ST
3.1 - Cable
3.1 - Cable
selection
selection
The required cable is a straight
RS232 cable with male-male
connectors (Lode art. nr.
930912)
Connect the cable to the GE
MAC 1200ST to the port as
shown in the picture to the left.
Connect the cable to the
ergometer as described in
chapter "Hardware setup".
3.2 - Software Setup
3.2 - Software Setup
1. Switch on the ECG monitor
2. Select config
3. Select communication and press enter.
4. Select bautrate 4800 and press enter
5. Select ergometer/treadmill and select other
6. Now select Trackmaster out of the list and press enter.
7. Save setup to system by using the configure button.
3.3 - Ergometer setup
3.3 - Ergometer setup
The following protocol needs to be set in the Lode ergometer to communicate with the external
equipment.
Treadmill ergometer: Trackmaster
The next chapters describe the procedures to setup these protocols depending on the type of
ergometer.
4/21
INTERFACE SHEET - GE MAC 1200ST - CPET TREADMILL / VERSION: 1.0 - 2015-11-03
