TAKE TIME TO LOCATE THE BEST POSITION
If necessary power the Receiver and move it around
the vehicle until the required performance is achieved
Operate the Transmitter and observe the Receiver
internal LED’s.
Mount as
HIGH
as possible
AVOID
surfaces with
HEAVY VIBRATION
AVOID
DIRECT
SPRAY
from wheels
In a
HOT CLIMATE
fit in a
SHADED
position
Cable gland should face
DOWN
or
BACK
3
!
CAUTION
2
or Disconnect Battery
IDENTIFY POWER CONNECTION POINT
AND ISOLATE SUPPLY
Fuse
Remove fuse
Vehicle batteries contain gasses
which are flammable and explosive.
Wear eye protection and do not lean
over battery while disconnecting. Do
not wear metal jewellery.
!
WARNING
Wiring Instructions 92 and 93 Series
20 Function Receivers
9220RX.01E
Identify the components
1
Parts included in your kit.
1 x Receiver
1 x Transmitter complete with
1 x Lo-Cover
1 x Lanyard
Items not shown
2 x Cable Glands
1 x 9863 External Aerial
These instructions
(6 pages)
Indicator LED’s 1 through 20
Indicator LED - Master
5 Volts LED
Set LED
Fault LED
LED’s indicate the following
LED
marked “5V” indicates
power supply for control circuits
is OK
LED
marked “SET” indicates the
system active.
LED
marked “Fault” indicates an
overload is present; the system
cannot be reset until overload is
removed.
This LED blinks for 20 seconds
when the system is initially
powered. A replacement
Transmitter (or Keypad or Wired
Remote) has to be registered
during this 20 second period.
LED’s marked F1 to F16 and M
(and optional MC) when ON
indicate an output to that function
(MC is an extra Continuous
Master output)
