Loctite HYSOL 175-AIR, Руководство по эксплуатации

Страница: 5 / 14

Steps 1 – 5 should be followed before connection to the main supply :
1. Insert the applicator stand into the grooves at the base of the handle.
Stand applicator on a flat surface.
2. Connect the air supply hose to a clean, dry and regulated air supply
using the Quick-Disconnect fitting provided (use of a filter/regulator is
recommended)
3. Pull the piston back fully and rotate upwards.
4. Load two adhesive cartridges into the barrel of the tool and push fully
forward.
5. Rotate the piston down and slide forward fully until it contacts the rear
of the adhesive cartridge - it should engage about 5/16" (6-8mm) into
the applicator barrel.
6. Connect tool to main power supply.
7. Red ‘Power On’ indicator light will illuminate.
8. Allow the applicator to thoroughly warm up for 10 minutes. Do not
attempt to operate the applicator until this time has elapsed.
5 Operation
Normal use:
•
Assemble the stand and place the applicator in an upright position on a flat
surface.
•
Plug the applicator into the power supply socket, and switch on the power .
Wait 10 minutes for the applicator to reach its normal operating temperature.
•
Squeeze the trigger to advance the piston and extrude molten adhesive
through the nozzle.
•
To stop extruding adhesive simply release the trigger.
During use, the piston will advance into the barrel as the trigger is pulled. A
point will be reached where the piston no longer advances, and the sound of air
escaping can be heard - this indicates that the applicator needs reloading.
•
Release the trigger.
•
Pull the piston back.
•
Insert a new adhesive cartridge.
•
Operate the tool normally.
2
3
5
1
4
USERS AIR SUPPLY