4) Always
start reading with the #4/3OS depth slide
tool, and then proceed to #, if necessary.
Fully
insert the depth slide into the AccuReader key. The
alignment mark on the depth slide will line up with the
(
Y
)
Yes
mark or it will line up with the (
N
)
No
mark.
a) If the #4/3OS depth slide lines up with the
Y
then the depth for space #6 wafer is a 4 or 3. If the
depth slide lines up with a
N
, then you must proceed to
the #2 depth slide.
b) If the #2OS depth slide lines up with the
Y
then the depth for space #6 wafer is a 2OS. If the
depth slide lines up with a
N
, then the depth for space
#6 is a 1.
c) Repeat steps a & b for each wafer position
until you have recorded the depth for all 6 positions.
d) Cut all 1’s to 1’s, 2’s to 2’s and 4/3 depths to
a 3.5. The key should turn in the lock relatively easily,
do not force. Any spaces that marked should be
moved to a 4 depth and any spaces that did not mark
should be recut to a 3 depth.
e) You now have recorded all the positions to
make a complete key.
TIPS& SUGGESTIONS
1) Always clean the keyway thoroughly before starting.
2) If the lock is worn, unusually dirty, or inconsistent, try reading from multiple locks.
3) Watch the demonstration video online at:
4) Keep slight upward pressure on the rear of the slide. This will keep the tip along
the bottom edge of the track as intended.
Please email us for any corrections or additions at [email protected] rev. 04-01-12