Installation Manual
Major Parts List
Front Handle Installation
Installation Instructions
1 2
3
4
5
6 7 8
9 10
11
12
1
- Inside Lever
2
-
Batte
ry Housing Cover
3
- Inside / Back Lock Housing
4
- Inside / Back Moun
ti
ng Plate
5
- Inside Gasket
6
- Latch
7
- Sprindle
8
- Outside / Front Gasket
9
- Outside / Front Lock Housing
10
- Indicator Light
11
- Key Override Cylinder
12
- Outside Lever
Fit the front lock housing onto the
front of the door. Feed the power
plug through the door hole.
1
2
Place the inside gasket on the inside
plate. Feed the power plug through
and secure the plate to door & front
lock with 3 screws.
Ensure that the key override slot is in
the horizontal posi
ti
on.
Slide the key cylinder into the back of
the handle.
Hold the inside lock housing up to the
inside of the door. Plug the front lock
power cable into the connector on the
back.
3
4
Insert the key into the key cylinder
from the front of the handle.
Slide the handle onto the driv
e shaft
unti
l it hits the catch pins.
5
Push the key in as far as it will go and
then turn 90 degrees clockwise.
6
Firmly press the lever
until it
snaps
over the catch pins. Turn the key back
to the left
and remove.
Place inside
lock over
moun
ting
plate
& secure with
screws.
Insert 4AA
batter
ies in to
the
batter
y
compartment.
www.RemoteLock.com
Insert latch
into the door
latch hole.
Secure the
latch with two
screws.
1
Drill the 3/8”
upper support
hole into the
door 3
5/16
”
above the
center of
boring hole.
2
Place the
front side
rubber gasket
(if required)
on the back of
the front lock
housing.
3
Insert the
square
spindle into
the center
hub. Ensure
dot is pointed
left.
4
5
7
Secure the inside lock housing
battery c
over with two screws.
10
Slide the inside lever into place.
Press firmly undil the handle snaps
over the catch pins.
11
8
9
6
