LS-PTC300 CAMERA MANUAL
Hardware Installation
1) Insert the power cable and the Wi-Fi antenna into their respective ports on the camera. Tighten the
Wi-Fi antenna until it is secure and not loose.
2) Insert one end of the Ethernet cable into the camera’s Ethernet port and insert the other end into an
open port on your router.
Please note:
Initial installation requires an Ethernet cable to be used to configure the camera to your
wireless network. After the camera is configured, the Ethernet cable can be removed from the camera to
only use the wireless connection (power cycle required). If the wireless network’s credentials change then
the device will need to be reconfigured using the Ethernet cable.
3) Plug the AC adaptor into a compatible wall outlet for power.
4) The “audio output” port is for external speakers and is optional.
Camera Provisioning – UPnP method
If Universal Plug and Play is enabled on the connected router, the web portal can setup the camera’s
wireless settings as well as the necessary IP information.
Please note:
If this method does not work and you receive a message stating “Camera Information
Received, But Cannot Configure Camera”, then proceed to the “Camera Provisioning – Port Forwarding
method”.
1) Navigate to https://connect.devicewebmanager.com and sign in to the administrator account. If no
account has been created, please create one via the “Sign Up” link on the login page.
2) Navigate to the camera tab on the dashboard and select “New Camera”.
3) Complete the name, MAC address (found on the bottom of the camera), model, and property fields.
Once completed, select “Create Camera”.
4) Follow the on screen prompts to complete camera installation and setup.
5) If a message comes up stating “Camera Information Received, But Cannot Configure Camera” then
proceed to the Non-UPnP method below.
