Copyright © 12/2015 Lockmasters, Inc.
5
Preparing the Magnum Bullet II™
5a. Remove the Tower from the Drill base.
(Figure 3).
b. Attach the Bullet Drill Base to the template
at the desired drill point using two (2)
8-32 socket head cap screws provided and
tighten securely.
c. Attach the Quick Disconnect Bullet Tower to
the Bullet Drill Base.
Operating the Magnum Bullet II
6a. With the Barrel and Quill Assembly in hand,
and viewing from the chuck end, hold the
chuck collar with one hand while rotating
the chuck sleeve counterclockwise with the
other hand. Open chuck to approximate drill
bit diameter.
b. Insert a clean bit up to the drill bit flutes for
small bits, or as far as it will go for larger bits.
5a. Removing Tower from Bullet Drill Base.
5b. Attaching the Bullet Drill Base to the
template.
Figure 3
5c. Attaching the Quick Disconnect Bullet
Tower to the Bullet Drill Base.
6a. Prepping the Barrel and Quill Assembly
by rotating the chuck sleeve counterclock
-
wise, opening the chuck to approximate drill
bit diameter. Inserting a clean drill bit in the
Barrel and Quill Assembly.