L110C/L110 SLIDING GATE OPERATOR
8
Drive sprocket
Driven sprocket
Driven sprocket
Fig.9
Sprocket cover
Mount the sprocket cover with screws.
Limit switch
L110C-Magnets for limit switch (see Fig.10)
Install the magnet as shown in Fig.10 below. The magnet and limit switch are used to
control the position of the gate.
When the magnet is installed, release the gear clutch and push the sliding gate manually to
pre-determine the position. Fix the magnet bracket to the gate and then tighten the gear
clutch. The lower bracket is for open position and upper bracket is for close position.
Finally adjust the magnet to the proper position by moving the gate with the motor. The
magnet should be 10~15mm away from the magnetic limit switch. If it is too far away, the
switch will fail to work. Adjust the position of the magnet until the positions of the opening
and closing meet the requirement.
Please note the position of two magnet brackets (fixed plate) are different: one is
upper and another is lower. Verify and if necessary exchange the two brackets
position. Also if necessary exchange the limit switch wires CL (close) and OP
(open).
Release key
Gate operator
Gate
Upper and lower Magnets
Sprocket cover
Drive sprocket
Magnet bracket
Fig.10 L110C
