Lochinvar EcoShield SHW116-410CE, Инструкции по установке, пусконаладке и обслуживанию

Страница: 5 / 72

5
1.0 INTRODUCTION

The Lochinvar EcoShield™ range is a floor standing direct gas-fired condensing storage water heater. The equipment comprises a
stainless steel mesh radial burner assembly; a heat exchanger that permits fully condensing operation, a vitreous enamel lined steel
storage vessel, a Stainless Steel circulating pump and interconnecting pipework between the storage vessel and heat exchanger.

The burner is initiated by a full electronic ignition sequence control that incorporates a spark ignition and a flame rectification device
for supervision of the flame.

The output from the water heater is regulated by a variable speed combustion fan and gas/air ratio controls to maintain the correct
combustion at all levels of modulation. This configuration allows modulation down to 20% of the rated output.

This equipment is intended for use on Group H Natural Gas (2
nd
Family) and LPG propane (3
rd
Family). The information relating to
propane firing is to be found in Section 16.0: LPG FUEL.
This equipment MUST NOT use gas other than that for which it has been designed and adjusted.

This equipment must be installed by a competent person, registered with a HSE approved body. All installations must conform to the
relevant Gas Safety and Building Regulations. Health & Safety requirements must also be taken into account when installing any
equipment. Failure to comply with the above may lead to prosecution.

If the equipment is to be connected to an unvented (pressurised) system, care must be taken to ensure all extra safety requirements
are satisfied should a high or low-pressure condition occur in the system.

The equipment is designed for direct connection to a flue system.

Ancillary Options:

Unvented Water System Kits SHW35-SHW61 WH19

Unvented Water System Kits SHW86-SHW146 WH21

De-stratification Pump Kit WH9

Condensate Neutralisation Kit KIT2000

Flue System Components See section 10.0