���
®
OPERATING INSTRUCTIONS
Court Placement
To ensure the best position and widest range of sweep, align
the white line marker on the bottom of the machine with the
baseline, placing the machine at the center mark (as shown to
the right).
If desired, move the machine closer to the net to narrow
the sweep or move it back from the baseline to widen it.
To reposition the machine, turn on the horizontal sweep and
turn it off when the machine is in the desired position—It is
not necessary to pick up the machine.
Ball Consistency
The consistency of ball throws is dependent on the pickle balls you use. A mixture of
pickle ball brands will produce inconsistent throws.
Power the Machine
Turn the machine on using the POWER switch on the control panel.
• Set the FEED anywhere from 2-12 seconds. 12 seconds is the slowest setting.
• Put 3-4 balls in the machine and wait 20 seconds for the machine to start
feeding. Confirm the elevation, speed, and spin are as desired; adjust if
necessary. Once you have set the machine to your liking, turn the POWER switch
OFF; fill the hopper with balls, and then power on the machine again.
• A 20 second delay allows time to get to the other side of the court before the
first throw.
• When the hopper is empty, turn OFF the FEED by rotating the knob fully
counterclockwise without turning machine off. This will save battery capacity
and allow time to retrieve balls on the court.
2-Line Oscillation Setup
The 2-line function automatically throws to two preset locations allowing you to
practice alternating forehand and backhand shots.
NOTE
: The ball hopper MUST
have balls in it for the 2-line oscillation feature to work.
• Fill the hopper, then turn the POWER switch ON.
• Set SPEED knob to desired speed.
• Turn HORIZONTAL SWEEP switch ON.
• Turn the 2-LINE switch to ON.
• For an 4-second interval per ball, set the FEED from 2-8 seconds.
• For an 8-second interval per ball, set the FEED from 10-12 seconds.
