Suction nozzle not visible.
Attach stopper bolt whilst in this position.
䠕
䠍
ᾀ
Cross recessed pan head screw (M4)
Phillips screwdriver
䐟
Shut off the air and electric power supply, and disconnect the air tube and power cable.
㻖㻌
Remove the bolt while holding the rivet
feeding unit to prevent it from dropping.
䐢
Retighten the stopper bolt at the angle to be used.
Stopper bolt
Rivet feeding unit
Hex key wrench
Set the angle of the rivet feeding unit to an angle of your choice.
(It can be adjusted to three diff erent angles, from directly above 0°, 30°, and 60°.
It is set at 0° in the factory default settings.)
䐠
Loosen 2 pan head screws (M4) by about 5 mm with a Phillips head screwdriver to
raise the acrylic cover, and remove the front urethane cover.
ᒍᛖᾔ
ᾝ
ᾖ
ᾛᾘ
ᾢ
ᾗ
⅐ ⁂⁄‷⁂″⁄″⁆※⁁⁀‒‴‷‸⁁⁄‷‒⁇⁅‷
Suction nozzle visible.
Ḵ
Suction nozzle
Rotating shaft
Turn in direction of the arrow
㻚
㻖㻌
The rotating shaft is free to move (can be rotated up and down).
Turn it in the arrow direction and attach the stopper bolt when the suction nozzle is not visible.
Front urethane cover
Ḵ
ḳ
Acrylic cover
䐡
Remove the stopper bolt with a hexagonal key wrench (5 mm opposite fl ats).
㻖
Do not remove height adjuster screw.
Height adjuster screw
ḳ
