Phone: 800.526.4041
Fax: 818.764.6061
TS- My Machine Won’t Calibrate.
Trouble Shooting
Test button to shoot a ball out and make sure that the ball
lands 1 foot past the Service line.
Step 3.
Go into the pre-programed drill you were
calibrating to, and press play. If balls are still hitting the
net, then go back and adjust the Test Ball distance so that
it hits 2 feet in front of the Service line.
If the issue continues, move to Section 3.
Test Button.
3
SECTION 2.
Calibrating Your Machine So The Balls Stop
Shooting Past The Baseline.
Most pre-programmed drills work with the Test ball
calibrated to land on the Center of the T on the Service
line. How-ever some pre-programmed drills may cause
the ball to shoot past the baseline in this case you will
need to follow the directions below.
Step 1.
With your machine lined up at the baseline press
the Test button.
Step 2.
Use the - button so that your distance is
approximately 1 to 2 feet behind the Service line. Press
the Test button to shoot a ball out and make sure that the
ball lands 1 foot behind the Service line (closer to the
net).
Step 3.
Go into the pre-programed drill you were
calibrating to, and press play. If balls are shooting past
the baseline, then go back and adjust the Test Ball
distance so that it hits 2 feet in behind the Service line.
If the issue continues, move to Section 3.
Start Up Screen.
Calibration Screen.
Test Button.
4
SECTION 3.
Checking The Magnets On Your Server Wheels
In Rare cases the machine may not calibrate correctly, or
still continue shooting balls into the net, or past the
baseline despite the Test ball being shot 1 to 2 feet past
or behind the Service line (sections 1 and 2). If this is the
case please follow the steps below.
Case Screws (Front & Rear)
