LIGHT MOUNTING SYSTEMS AUSTRALIA – (LMS)
UNIT 1, 33 MUSTANG DRIVE, RUTHERFORD NSW 2320
INSTRUCTIONS – LMS080
PH: 02 4932 9000 FX: 02 4932 9009 EM: [email protected]
OPERATION:
CAUTION: - ALWAYS STAND TO THE SIDE OF OVERHEAD EQUIPMENT WHEN RAISING OR LOWERING
Lowering trolley and Equipment
Remove cable cover
(5)
and remove cable ties if installed.
Rotate winch handle clockwise to raise trolley off locking lever arm
(6)
.
Pull down on Locking Lever Arm cable adjacent to winch. This will pull Locking Lever Arm arm
(6)
back into track section
(1)
allowing head trolley to lower. Rotate winch handle anti-clockwise and lower trolley past retained locking lever arm. Release
Locking Lever Arm cable and continue to turn winch handle anti-clockwise to lower trolley and equipment down for
maintenance.
Raising Trolley and Equipment
With trolley in lowered position, turn handle clockwise to wind cable onto winch and raise trolley and equipment
Raise trolley until it passes Locking Lever Arm
(6)
which will spring back to normal position after trolley passes.
DO NOT
keep winding winch with trolley against stopper
(7)
as this will put undue stress on winch cable and may cause damage.
Turn winch handle anti-clockwise to lower trolley onto Locking Lever Arm
(6)
so trolley and equipment is not supported on
winch cable. Leave just enough tension on winch cable to keep it tight.
If there is a small amount of slack cable after lowering trolley onto locking arm hand tension cable and install cable ties through
four holes in winch track section just above winch to keep cable flat on winch track section.
Install cable cover
(5)
onto track
(3)
.
MAINTENANCE:
It is recommended that the following points be inspected or checked for operation whenever system is used.
1.
Operation and condition of winch and cable
2.
Operation of locking lever arm
3.
Attachment point of cable to trolley
4.
Condition of power cable
5.
Condition of track sections