LLOYTRON Coral, Руководство по эксплуатации, Страница: 5 / 8

5
oPeRATIoN
IRoNING TIPS
1. Sort the articles to be ironed according to the fabric. Ironing instructions are usually stitched
onto an inside seam of the garment and these should be followed at all the times. Start your
ironing with the fabrics requiring the lowest heat setting.
2. If you are unsure of the fibre content of a garment, test a small area (a seam or inside hem)
before ironing.
3. When in doubt, start with low heat. If wrinkles remain, gradually increase heat to find the best
setting for good results without damaging the fabric.
FIRST USe oF YoUR IRoN
1. Before using for the first time, check if the voltage rating on the base plate corresponds to the
mains voltage in your home.
2. Remove any labels or stickers on the iron.
3. Some parts of the iron have been slightly greased and as a result the iron may smoke slightly
when switched on for the first time. After a short while, however, this will cease.
Warning: The iron must not be left unattended while it is connected to the supply
dRY IRoN
1. Stand the iron on the heel rest, and then plug the iron in.
2. Turn the control knob to ‘MIN’.
3. Adjust the dial to the proper temperature control.
4. When the pilot lamp goes out, it indicates the iron has reached the required temperature.
SToRAGe
Be sure the iron is unplugged first. Let iron cool completely before storing. Do not wrap cord around iron.
mAINTeNANCe:
This appliance has been designed to operate over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper care and regular cleaning.
WARNING! Before performing any maintenance or cleaning on this appliance, disconnect the appliance
from the electricity supply.
CleANING! The exterior surface of the appliance should be cleaned with a damp cloth only
do NoT USe ABRASIVe CleANeRS oN ANY PART oF THIS APPlIANCe.
CleANING ANd CARe
Turn your temperature control dial to the position you desire according to the following fabric indications:
TemPeRATURe CoNTRol
Synthetics
Synthetiques
Chemiefasern
Silk/Wool
Soie/Laine
Seide/Wolle
Linen/Cotton
Toile/Coton
Leinen/Baumwolle
1. To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.
2. If an extension cord is absolutely necessary, a 13-ampere cord should be used. Cords rated for less
amperage may overheat. Care should be taken to arrange the cord so that it cannot be pulled or
tripped over.
SPeCIAl INSTRUCTIoNS