
side between the freezer and wall, 200mm space between back of the Freezer
and the wall, and 300mm space between the counter top and the roof or ceiling.
If you are installing the Freezer
hinge side to allow the door to swing open.
Never install the Freezer
near heat source and direct sunlight.
ELECTRICAL REQUIREMENT
WARNING: DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTOR.
DO NOT USE AN EXTENSION CORD.
Failure to follow these instruct
Before moving the Freezer
you have the proper electrical connection.
Recommended Earthing Method
A 220
~
240 Volt /50 Hz AC, 10 ampere fuse and properly earthed electrical
supply is required. It is recommended that a separate circuit serving only for this
appliance be provided. Use a receptacle which cannot be turned off with a switch
or pull chain. Do not use an extension cord.
NOTE:
Before performing any type of installation, disconnect the Freezer from
the electrical source. When you are done, connect the Freezer to the electrical
source and reset the control to the desired setting.
LEVELLING
If the Freezer is not levelled during the installation, the doors may not close or seal
properly, causing cooling, frost, or moisture problems. It is very important for the
6
Содержание LDR275W
