www.livoo.fr
Figure 2
1.
Insert the hose hook into the machine.
2.
Remove the clean water tank from the body.
3.
Open the screw cap and fill it with clean water. Respect the maximum water level mark.
4.
Install the clean water bucket into the body.
5.
Insert the handle into the brush.
6.
Fix the hose (Figure 1 N°4) and power cord ( figure 1 N° 7) before use.
Use of the device
Figure 3
1.
Plug in the machine and press the on/off button.
2.
Press the spray button to spray your water/detergent mixture.
3.
Do not spray continuously in the same place.
4.
After spraying, press the suction inlet part of the brush on the spot to absorb the water.
Note: When the wastewater tank reaches the maximum water level, stop working and turn off the
power
5.
Turn off your appliance and unplug it. Drain the clean water and waste water, and clean the waste
water tank.
Note : after using the device, the textile will still be humid or a little wet. To avoid any unpleasant odour,
you can dry the textile with an hair dryer or expose it to the sun.
Figure 4
For stubborn dirt, apply the water/detergent mixture
on the surface to be cleaned and rub the dirt with the
brush. Use the device to absorb the dirt and most of the water/detergent mixture.
Example of recommended detergent:
Strong alkaline ionized water, baking soda, citric acid, weak acid
electrolytic water such as detergent producing less foam.
Example of not appropriate
detergent :
Neutral detergent for kitchen use, strongly alkaline detergent,
strongly acidic detergent.
When using a detergent with a lot of foam, the foam might get inside the cleaner.
Note:
When using detergent, first test it on the edge of the fabric being cleaned to make sure that there
is no discoloration.
When the wastewater tank reaches the maximum water level, turn off the device and empty the tank.
Only use clean water or recommended detergent at temperature less than 40°C to fill the clean water
tank.
Cleaning and maintenance
Cleaning of the clean water tank:
Figure 5
Take out the clean water tank. Unscrew the cap at the bottom of the tank and pour away the remaining
water.
Replace the tank and then turn on the power again. Press the watering button to remove the remaining
water. Tilt slightly the machine if necessary.
Cleaning of the wastewater tank Figure 6
When the wastewater tank reaches the maximum water level, turn off the device and empty the tank.
Содержание DOH134
Страница 2: ...www livoo fr...
