Instruction manual
5
INSTRUCTIONS FOR USE
Follow these instructions carefully to avoid seriously damaging your barbecue and causing injury to
yourself and to property.
1.
Assemble the barbecue following the assembly instructions carefully.
2.
Connect the gas hose to the barbecue. Connect the regulator to the hose.
3.
Connect the regulator to the cylinder valve following the regulator instructions supplied with the
regulator.
4.
Turn all of the control knobs to the ‘OFF’ position before turning on the gas supply to the appliance.
5.
Operate the regulator in accordance with the instructions supplied with the regulator.
LIGHTING INSTRUCTIONS: MAIN BURNERS
1.
Connect the gas cylinder to the barbecue following the instructions supplied with the regulator.
2.
Turn all the control knobs to the ‘OFF’ position.
3.
Turn ‘ON’ the gas supply at the cylinder or regulator switch following the regulator connection and
operating instructions. Check the cylinder to regulator connection and hose to barbecue hose inlet
connection for leakage using soapy water. Any leakage will show as bubbles in the area of the leak. If
leak is found, do not use the barbecue and turn off the gas supply. Consult your gas or barbecue
supplier for advice.
4.
Before ignition, open the lid if there is .To light the left hand burner, push down and turn the left burner
control knob anticlockwise to the 90° position (Full rate position). An audible click will be heard, this
should light the burner. Check that the burner is alight. If the burner has not lit, repeat this process.
5.
If the burner has not lit after two attempts, turn ‘OFF’ the gas tap and wait 5 minutes before retrying
the ignition sequence.
6.
When the burner has lit, the burner rate can be adjusted by turning the knob anticlockwise to any
position between the full and low rate positions.
7.
Light the remaining burners from left to right in sequence.
8.
To switch on the right burner, press on the right button quite there the turning point counter clockwise
up to the position " big flame " ( full power), at the same time quickly press on the button of ignition
(situated between both buttons) 4 times in succession. This will switch on the right burner. If it does
not work repeat the operation.
9.
If the burner does not ignite after 2 tries, cut the gas inlet by turning the button on "Stop" and wait 5
minutes before re-trying to to switch on it.
10.
If the burner does not remain switched on, repeat the stage 8.
11.
When the burner is switched on. Adjust the power by turning the button to the positions " small flame
" or the " big flame " .re- trying to switch on it.
12.
To switch off the plancha, cut the gas inlet by turning the button of the valve or the regulator in position
"Stop", by following the instructions supplied with the regulator. Turn the buttons of all the burners in
the directions of watch hands, in position "Stop" switched off,(faded), when flames are switched off.
