10
11
Attention
Please note that the label states that this item may not be ironed
Label reference
Type of fabric
Thermostat knob
Nylon
MIN
MAX
Wool/Silk
Cotton/Linen
CLEANING AND MAINTENANCE
Before cleaning, disconnect the mains plug from the socket and allow the iron to cool down sufficiently.
1. Wipe the soleplate with a damp cloth and a non-abrasive (liquid) cleaner.
2. If fibres stick to the soleplate, use a toothpick. Do not damage the surface of the soleplate.
3. Never use strong acid or alkali to avoid damaging the soleplate.
4. If deposits are blocking the steam hole of the iron soleplate, remove them with a damp cloth and vinegar.
5. Place the iron vertically and allow it to cool sufficiently. Pour the remaining water out of the container and set the
steam selector to „no steam“.
NOTE: Deposits or minerals in the water will cause scale to form and block the steam holes. It is therefore advisable to
use distilled water.
TROUBLESHOOTING
Problem
Possible reason
Possible solution
Not enough heat
Thermostat dial set too low or iron is
not connected
Adjust the thermostat dial or connect
the power supply.
No steam
The thermostat dial has been set
too low.
Set the thermostat switch to the
desired position.
No steam burst or no vertical
steam
The steam burst function is being
used very often within a short time
(iron is not hot enough).
Continue ironing in the horizontal
position and wait a while before
using the (vertical) steam burst
function again
Water is leaking from the soleplate
The thermostat dial is located
outside the steam range.
Set the thermostat control to the
steam range.
Not hot enough
Only set the steam selector switch to
the steam position
after the indicator light has gone out
M29899 M29898_Livington_IronFlex_Manual_20210607_DR.indd 10
M29899 M29898_Livington_IronFlex_Manual_20210607_DR.indd 10
14.06.21 12:09
14.06.21 12:09
