PAGE 3 OF 3
Scan QR code to view assembly video
Height Range
Base Width
Travel Speed
Weight Capacity
Duty cycle
27.5in-46.5in (without desktop)
41.75in
0.75in per second(no load)
176LBS
10%. Max. 2 mins on, 18 mins off
Soft start/stop
Adjustable leveling studs
4 Memory presets
This height adjustable desk has electric motors and is designed for
use in dry work areas only.
The desk height is adjustable so that it can be positioned at the most
ergonomically suitable height.
Any other use is at user’
s risk.
Under no circumstances does the manufacturer accept warranty
claims or liability claims for damage caused from improper use or
handling of the desk frame.
Caution / Information
WARNING
Pinch Point
Keep hands and
fingers clear
Make sure no obstacles are in the desk’
s path.
Make sure the desktop is not touching any walls.
Make sure all cords are appropriate length to
accommodate the change in height.
Keep children away from electric height-adjustable desks,
control units and handsets. There is a risk of injury and electric shock
Do not sit or stand on the desk frame.
Do not crawl or lie under the desk frame.
Keep all electrical components away from liquids.
Do not place any objects taller than 20” underneath the desk.
Do not open any of the components ---the Legs, Control Box, or Switch.
There is a danger of electric shock.
This product is designed with a duty cycle of 10%. (2 min. on, 18 min. off)
In the event of a power outage or if the power cord is unplugged,
a manual reset may be necessary--see Switch Instruction.
Use/Liability
Switch Instruction
Troubleshooting
If your desk is not functioning properly it may need to be reset. Unplug the power cord for 20 seconds.
Plug the power cord back in and follow the RESET procedure outlined in Switch Instruction.
If your desk has a handset with an LED readout and it displays “rES”(reset), perform the reset
procedure outlined in Switch Instruction.
If the LED readout displays an error message (“E01”-- “E60”) confirm that all wired connections are
secure(legs to cables, cables to control box). Then perform the reset procedure outlined in Switch Instruction.
If the error message persists after the reset procedure, contact your seller.
If the height between the legs exceeds 1.5 inches, stop the reset procedure&contact your seller.
If the handset displays “HOT”, let the base cool down for 18 minutes.
Plug the Power Cord into a 110V-240V outlet.
Important: You must Reset the desk prior to use.
Reset Procedure: Press and hold the DOWN button on the Switch until the desk reaches its lowest height.
Release the DOWN button. Press and hold the DOWN button again until the LED display reads “rES” or
about 10 seconds on non-LED handset models. Release the DOWN button. Press and hold the DOWN button
again until the desk lowers a little bit more, slightly rises and stops. Release the DOWN button. Your desk is
now ready to use.
To program up to four presets (on some models): Use the up/down buttons to find a desired height, then
press “M”(“S” on some models) followed by a number 1--4.
Conversion of metric and English units:
Press the “M” for 3 seconds until the display shows“---”.
Press the “M” again.
When the screen flashes, press the “M”again.
After that, the screen displays “1”, press the “DOWN”.
When the screen display “S1”, and then press “ M”.
Caution: Once a preset button is pushed, the desk will move to the programmed
height(see caution box above).
Make sure no obstacles are in the desk’s path.
Make sure the desktop is not touching any walls.
Make sure all cords are appropriate length to
accommodate the change in height.
