Living & Co MK5700-SA, Инструкция по эксплуатации

Страница: 7 / 12

OPERATION OF YOUR MILK FROTHER
1. Place the appliance on a flat surface.
2. Select appropriate paddle depending on your desired function.
I. Frothing and heating milk (use frothing paddle);
II. Frothing milk, without heating (use frothing paddle);
III.Heating milk, without frothing (use mixing paddle).
Open the jug lid, insert the relevant paddle and clip onto the shaft on the bottom of jug.
3. Fill the jug with the desired amount of milk, and replace the lid.
NOTE:
The maximum milk quantity permitted is 150ml for frothing and 300 ml for warming
only (see Fig.1), this is to avoid milk overflowing after frothing. The minimum milk quantity
permitted is 75ml.
NOTE:
Whole milk is recommended, refrigerator chilled (5-10
℃
).
4. Connect the plug to a power outlet.
5. Press the relevant button (Heat or Froth) once.
I. Frothing and heating milk (use Heat button);
II. Frothing milk, without heating (use Froth button);
III.Heating milk, without frothing (use Heat button).
Depending on the button pressed, the relevant indicator will light up (blue colour for
Froth button and red colour for Heat button) and the appliance will start to operate. If
heating, once the milk temperature has reached its set value (approximately 67°C) , the
appliance will cease operation , this will take approximately 3 minutes .
If frothing without heating, the appliance will operate for a preset time (approximately 2
minutes) an d will then cease operation.
NOTE: You can stop operating at any time by pressing the heat or froth button once.
6. When the appliance has stopped operating, open the lid, pour out the milk to enjoy.
Caution: A m inimum of 3 minutes rest time must be maintained between two continuous
cycles. Ot her wise, the appliance will enter self-protection state (to avoid overheating)
automatically after 5 continuous cycles as indicated by the indicator lights flashing. The
heat and froth buttons will be inoperable while in self-protection state. After about 5
minutes, the appliance will return to standby state and you can continue operating the
appliance.
7. Always turn off the milk frother and disconnect the power supply when not in use
NOTE: Please clean the jug according to the section “CLEANING AND MAINTENANCE”
after two continuous cycles.
6