86,1* <285 :$7(5 .(77/(
1. To fill the kettle, remove it from the power base and open the lid by pressing
/LG
5HOHDVH
button, fill with the desired amount of water, and then close the lid.
Alternatively, the kettle may be filled through the spout. The water level should not
exceed MAX marks or sit below MIN level. Too little water will result in the kettle
switching off before the water has boiled.
127(
Do not fill the water over the maximum level, as water may spill out of the
spout when boiling. Ensure that the lid is firmly in place before plugging the power
outlet.
2. Lay the kettle on the power base and connect the plug into a power outlet.
127(
Designed power base can be rotated by 360 degree to facilitate the plug
connecting with power outlet.
3. Press down the
2QRII
switch to “
,
” position, the working indicator will light up
ē
then
start to boil the water. The kettle will switch off automatically once the water has
boiled. You may shut off the power by pressing the “
” position or lift the kettle from
the Base at any moment to stop boiling process. If necessary
,
it will take you 30
seconds to wait for before you press the switch again to re-boil water.
127(
ġ
Ensure that switch is free of obstructions and the lid is firmly closed.The kettle
will not turn off if the switch is constrained or if the lid is opening.
4. Lift the kettle from the power base and then pour the water.
127(
Operate carefully when pouring the water from your kettle as boiling water
may result in scald, besides, don’t open the lid while the water in the kettle is hot.
5. The kettle will not re-boil until the switch is pressed again. The kettle may be stored on
the power base when not in use.
127(
Ensure power supply is turned off when kettle is not in use.
%2,/'5< 3527(&7,21
Should you accidentally let the kettle operate without water, the boil-dry protection will
automatically switch off the power. If this occurs, allow the kettle to cool before filling
with cold water to re-boil.
NZ 0800 422 274
