４
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is recommended that you clean
your kettle before use by boiling the Maximum capacity of water once and then
discarding the water, repeat this step twice. Wipe the surface with a damp cloth
once cooled.
USING YOUR KETTLE:
1. Place the kettle on a flat surface.
2. To fill the kettle, remove it from the power base and remove the lid, then fill
the kettle with the desired amount of water and replace the lid. The water level
must be between the Min and the Max levels. Too little water will cause the
kettle to switch off automatically before the water has boiled or, will cause the
kettle to “dry boil” activating the overtemperature protective device.
NOTE: Do not fill the water over the maximum level, as water may spill out of
the spout when boiling. Ensure that the lid is firmly in place before plugging
into the power outlet.
3. Position the kettle on the power base.
4. Connect the plug into a power outlet. Press down the on/off (boil) switch and
the indicator will light up, the kettle will then start to heat the water. The kettle
will switch off automatically once the water has boiled. Please allow at least 30
seconds before pressing the switch again to re-boil the water. You may shut off
the power by lifting the switch up or directly lift the kettle from the power base
at any moment to stop the boiling process.
NOTE: Ensure that the switch is free of obstructions and the lid is firmly closed
during operation.
5. Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your kettle as boiling
water may result in scalding. Do not open the lid while there is hot water in the
kettle.
6. The kettle will not re-boil until the switch is pressed again. The kettle may be
stored on the power base when not in use.
NOTE: Always disconnect the power supply when not in use.
