• Connect the transformer (fig.1 - ref.9) by inserting the plug into the appliance socket (fig.1
- ref.5). Or connect the transformer to the base (fig.1 - ref.6) by inserting the plug into the
base plug (fig.1 - ref.7), then sit the appliance onthe base.
• Plug the transformer into the mains.
• During charging the led (fig.1 - ref.4) lights up to indicate charging in progress.
• Only recharge the battery when you note a clear reduction in appliance power.
• When the battery is fully charged, the appliance can be used for 60 minutes without
connection to the mains.
REMOVING AND ADJUSTING THE COMB ATTACHMENT
• To adjust the cutting length, slide the comb as illustrated in figure 2: move it in the
direction of arrow A to increase the cutting length, or in the direction of arrow B to
decrease the cutting length.
• To remove the comb, move it in the direction of arrow A until it slides off the appliance
completely.
CHANGING BLADES
• Switch the appliance off.
• To remove a blade, push to release from the seat as shown in (fig.3).
• To refit a blade, follow the instructions in (fig.4): first insert the rear section in the seat (A),
then push the front to secure in place (B).
CARE AND MAINTENANCE
The cleaning and maintenance procedure must be carried out after every use.
• All maintenance or blade change operations must be carried out with the appliance
switched OFF and removed from the mains adapter.
• Never immerse the appliance in water!
• After every use, remove the guide comb then use the small brush to eliminate any hair
from the cutting head and its seat.
• Clean the outside of the appliance with a soft cloth (slightly damp if necessary). Never use
solvents or abrasive detergents!
• Remove the cutting head (fig.5) and evenly oil the blades and the seat of the motor pin
which is located on the inside.
• If after prolonged use, and despite regular cleaning and lubrication, the cutting ability of
the appliance appears to be diminished, the cutting head must be replaced.
• Once the appliance has been cleaned, the guide comb can be fitted back in place since it
also helps to protect the blade.
EN
5
