9
GB/IE/NI
Note:
If the LED work lamp has not been charged for an extended period of time (approx. 2 months),
you could find that the integral rechargeable batteries have entered a dormant state. Charge and
discharge the LED work lamp a number of times in succession to reactivate the integral rechargeable
batteries.
Note:
You can choose to charge the LED work lamp directly via the mains adapter or via the charging
station.
Before charging, switch
the LED work lamp off (press ON / OFF switch
4
).
To charge the LED work lamp via mains adapter
10
directly, plug the male connector of the mains
adapter into the female connector on the work light
7
.
To charge the LED work lamp via the charging station, plug the male connector of the mains adapter
into the female connector on the charging station
9
. Then place the LED work lamp into the charg-
ing station to charge the product (See Fig. B).
Note:
The product is fitted with an overcharge protection circuit. Despite this, you should disconnect
the LED inspection lamp from the power supply after the charging process is complete.
Note:
During charging, the charge indicator LED lights up red. When charging is complete, the
charge indicator LED lights up green. When the charge indicator LED is green, pull the mains adapter
out of the socket. Disconnect the adapter from the LED work lamp to prevent the batteries from
discharging.
Q
Use
CAUTION – RISK OF ACCIDENT!
Always store and secure the LED work lamp in such a way
that there is no risk of injury from or damage to the product, even during full braking.
Note:
The LED work light features magnets
6
on the back. Ensure the metallic surface is sufficiently
magnetisable to carry the weight of the light, before you use the magnets
6
.
Using the LED work light without a power connection
Fully charge the LED work lamp as described in the section “Charging the LED work lamp“.
Press the ON
/ OFF switch
4
to turn the inspection light
2
on.
Press the ON
/ OFF switch
4
again to turn the torch
1
on.
Press the ON
/ OFF switch
4
the third time, the entire LED work light will be switched off.
Corded use of the LED work lamp
Use the included mains adapter for this purpose. Using the respective adapter, connect the inspec-
tion light to a suitable power supply.
Then proceed as described under „Using the LED inspection light without a power connection“
(starting with step 2).
NOTE:
The LED work lamp can only be charged whilst off!
