8 GB/IE/NI
Remove the cap
22
carefully by a small flat
screwdriver (see Fig. J).
Release the locking screw
21
by turning it anti-
clockwise using a hexagon socket screw key
9
.
CAUTION!
Do not take the screw completely
out; just loosen it until the control lever
20
can
be easily taken off.
Take off the control lever
20
.
Loosen the cartridge end ring
23
by hand, then
screw off the cartridge locking ring
24
by using
a pipe wrench.
Now pull the setting ring
25
upwards with the
help of a screwdriver.
Note:
Do not remove the cartridge
26
.
Place the setting ring
25
in the desired position
as shown in Fig. K.
Note:
The setting ring
25
can limit the turning
angle of the handle, so that the amount of hot
water can be limited.
Tighten the cartridge locking ring
24
onto the
tap body
1
again by using a pipe wrench,
then tighten the cartridge end ring
23
by hand.
Place the control lever
20
back on to the tap
body
1
and tighten the locking screw
21
by
turning it clockwise using a hexagon key
9
.
Press the cap
22
into the opening.
Turn on the main water supply and check the
temperature limiter.
Water-saving function
The cartridge
26
in this tap has a water saving
function. This feature limits the water flow through
the tap. This means you can save up to 50 %
water (see fig. L).
Lift the control lever
20
until you notice a slight
resistance. This resistance will cause a stop in
case of partial opening and will therefore simply
limit the flow of water.
If you want to increase the flow rate, exert slight
pressure on the control lever
20
until you over-
come the resistance.
Maintenance and cleaning
Tap care and cleaning
Please note that sanitary fittings require special care
and attention. Therefore you should follow the fol-
lowing advice:
Never use corrosive or alcohol-based materials
for cleaning, as these could damage the product.
Clean your fittings with clean water, mild detergent
and a soft cloth or leather only.
Screw out the mixer nozzle
27
at regular intervals
and remove lime deposits of foreign bodies.
Non-observance of the above care advice can be
expected to result in damage to the surface of the
fittings. In this event your rights under the warranty
may be invalidated.
Disposal
The packaging is made entirely of recyclable materials,
which you may dispose of at local recycling facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
Information
Potability of mains water
Find out about the potability of your mains water
supply. Your local water authority or water supply
company will be able to inform you.
The following general recommendations
apply to the potability of the water from
your pipework:
Let the water run freely for a short time if it has
been stagnating in the pipework for more than
four hours. Do not use any of this stagnant water
in the preparation of food or for drinking. This
applies particularly as far as babies and infants
