LIVARNO LUX 319420_1901, Инструкция по сборке, эксплуатации и безопасности

Страница: 12 / 106

12 GB/CY
Before installation ensure that the circuit, to which the product will be
connected, is not energised. To do so, remove the fuse or switch off the
circuit breaker in the fuse box (0 position).
Use a voltage tester to verify the de-energised status.
The included mounting material is suitable for ordinary solid concrete
or masonry construction. Check which mounting material is suitable
for your chosen mounting surface. If necessary, seek expert advice.
Installation
Make sure you will not be drilling into electrical, gas or water lines inside
the wall. Use a power drill to drill the holes into the brick wall. Always ob-
serve all safety instructions for the power drill in the ma nual for the power
drill. Death or injury due to electric shock may otherwise result.
When selecting the mounting location, pay attention to the following:
Select a sturdy and vibration-free wall.
Keep a minimum distance of approx. 20 cm to other objects to ensure
a good ventilation.
Only mount the product in one direction. The “UP” label on the
product resp. the arrow should be pointed upwards (see Fig. D).
Make sure that the LED spotlight
2
illuminates the desired area.
You can move the product vertically to adjust the angle.
Make sure the motion sensor
1
covers the desired area. The motion
sensor
1
has a maximum coverage range of 8 m, with a coverage
angle of about 160 ° (depending on the mounting height – a height
of 1.80–2.50 m is ideal).
Make sure the motion sensor
1
is not illuminated at night by street
lighting. This can influence its functioning.
Don’t adjust the motion sensor
1
onto trees, bushes or locations
where animals could be easily detected. Do not adjust the motion
sensor
1
to fan heaters, air conditioners, pools or other objects with
fast-changing temperatures.
Use the bracket
4
as a pattern to mark the drilling holes onto the
wall. Ensure that there are no cables or wires in this area in the wall.