LIVARNO LUX 307577 1904, Инструкция по сборке, эксплуатации и безопасности

Страница: 19 / 69

19 GB/IE
nection housing
7
, attach the silicon washers
3
, flat washers
4
and
secure with the two nuts
5
.
Check for correct fitting.
Insert the LED bulb
14
into the socket carefully with a cloth and tighten it with
a ¼ turn in a clockwise direction (see fig. G).
Place the lamp shade
1
on the lamp body
2
and tighten it. Ensure that the
sealing ring on the lamp body
2
and lower lamp shade
1
are present and
in contact (see fig. H).
Re-install the fuse for this circuit or switch on at the circuit breaker in the fuse box
(see fig. J). Your product is now ready to use.
Replacing a LED bulb
CAUTION! RISK OF ELECTRIC SHOCK!
To replace the LED bulb
14
, first of all disconnect the product from the mains
circuit. To do this, remove the fuse or switch off the circuit breaker in the fuse
box (0 setting).
Allow the product to cool completely.
Remove the lamp shade
1
from the lamp body
2
.
Turn the defective LED bulb
14
out of the socket with a ¼ turn anticlockwise.
Use a dry, lint-free cloth to replace a LED bulb
14
.
Insert a new LED bulb
14
in the socket and tighten it with a ¼ turn clockwise.
Check for correct fitting.
Place the lamp shade
1
over the lamp body
2
and screw tight. Be sure the
sealing ring makes contact with the lamp shade.
Re-install the fuse for this circuit or switch on at the circuit breaker in the fuse box.
Adjusting the motion sensor
Depending on the preadjustments of the motion sensor
15
, the product will switch
itself on for a certain period of time as soon as the motion sensor
15
detects movement.
These preadjustments are made using the three controllers on the underside of the
motion sensor
15
(see fig. I).
Setting the lighting duration
Turn the rotary control TIME
18
clockwise to increase the duration of the illumi-
nation. The lighting duration can be adjusted within a time window of approx.
10 seconds to 5 minutes.