LIVARNO LUX 288451, Инструкции по эксплуатации и безопасности

Страница: 7 / 44

8 GB
Safety / Preparing the product for use
only be replaced by the manufacturer, a service
representative of the manufacturer or a similar
specialist!
Before assembly, ensure that the mains voltage
available corresponds to the operating voltage
necessary of the light (see „Technical data“).
Never let the lamp come into contact with water
or other liquids.
Always unplug the light from the mains prior to
assembly, disassembly, cleaning or if the light
will not be used for extended periods.
Never open or insert anything into electrical
fittings or equipment. Doing this sort of thing can
lead to a serious danger to life from electric shock.
To avoid danger
of fire and injury
CAUTION! RISK OF INJURY!
Check bulbs for damage immediately after
unpacking. Do not fit defective bulbs into the
light. If they are, contact the service point for a
replacement.
CAUTION! RISK OF BURNS
DUE TO HOT SURFACES!
Ensure the lamp has been switched off and al-
lowed to cool before you touch it. In this way
you will avoid the danger of burns. Bulbs give
off a lot of heat around the top of the lamp.
Do not cover the light or the mains plug with
objects. Excessive heat can result in a fire.
Never leave the lamp operating unattended.
ATTENTION!
Do not look into the LED from a close distance
during operation.
Do not look at the LED with an optical instrument
(e.g. magnifier).
This light is not suitable for dimmer
or electronic switches.
The light bulb is not replaceable. If the light
bulb has reached the end of its life, the entire
light needs to be replaced.
Working safely
Install the light so that it is protected from
moisture and dirt.
Prepare carefully before assembly and allow
yourself enough time. Lay out all the individual
components and additional tools or materials
required so that you can see and reach them.
Remain alert at all times and always watch what
you are doing. Always proceed with caution
and do not assemble the lamp if you cannot
concentrate or feel unwell.
To disconnect the lamp completely from the
power supply, the mains plug must be discon-
nected from the mains socket.
Preparing the product for use
Assembling the lamp
Note: You will require a second person to help
with the assembly of the product.
Note: Please ensure that you pull the cable during
fitting slowly through the base.
Remove the transport lock
6
from the support
tube.
First insert the support tube
14
into the upper
support tube
15
of the torchiere and tighten.
Ensure not to pinch the mains lead running
through the support tube
14
.
Insert the support tube
7
for the reading light
into the flexible arm
3
and tighten.
Slide the support tube guide
13
over the
support tubes.
Insert the floor lamp with both support tubes
7
,
14
into the designated holes in the base
9
.
Place the serrated washers
10
over the support
tubes
7
,
14
on the underside of the base
9
.
Screw the nuts
11
clockwise over the support
tubes
7
,
14
using the tool
12
to secure the
floor lamp to the base
9
.
Note: Verify the support tubes
7
,
14
remain
steady when tightening the nuts
11
.