LIVARNO LUX 288404, Инструкция по сборке, эксплуатации и безопасности

Страница: 11 / 58

11 GB/IE/NI
then by turning the nut of the
cable gland
7
.
Connect the lead of the cable
with the terminal block
13
in
the connection box
6
. Pay at-
tention to the markings on the
terminal block
13
(L for live, N
for neutral and for the earth
wire) (Fig. C).
Close the connection box
6
.
Align the spotlight
1
into the
desired direction. For this, you
may need to slacken the fasten-
ing screws
8
. After finish the
alignment, tighten the fastening
screws
8
again, to ensure a
secure hold.
Reinsert the fuse or switch the circuit
breaker back on. Your product is
now ready to use.
Start-up
Adjusting the
motion detector
Depending on the pre-adjustments
of the motion detector
9
, the spot-
light
1
will switch itself on for a
certain period of time as soon as
the motion detector
9
detects
movement. These pre-adjustments
are made using the three controllers
on the underside of the motion
detector
9
(Fig. B).
Setting the
lighting duration
Turn the rotary control TIME
11
clockwise to increase the dura-
tion of the illumination. The
lighting duration can be adjusted
within a time window of approx.
10 seconds to 4 minutes.
Adjusting the sensi-
tivity of the sensor
Turn the rotary control SENS
10
clockwise to increase the sensi-
tivity of the sensor.
Note: The motion detector
9
responds to heat radiation.
When outdoor temperatures
are low, it is more sensitive to
body heat than when outdoor
temperatures are warm. Be