17
GB/IE
Safety / Preparation / Prior to installation
Initial use
Initial use
Mounting / installation of the
light (see Fig. A–I)
Before installation ensure that the circuit, to
which the light will be connected, is not ener-
gised. To do so, remove the fuse or switch off
the circuit breaker in the fuse box (0 position).
Mount the light fixture
1
in the desired posi-
tion. While doing so, observe the drill hole in
the light fixture
1
through which the power
cable is introduced.
Mark three drill holes
6
(see Fig. D).
Drill the holes. Be sure not to damage the
mains cable (external)
7
(see Fig. E).
Insert the wall plugs
5
in the drilled holes. If
necessary, use a hammer (see Fig. E).
Guide the power cable through the drill hole in
the light fixture
1
provided for this purpose
and attach the light to the ceiling (see Fig. F–G).
Connect the three building wires in the light fix-
ture‘s
1
terminal block
8
, as indicated by
the colours.
Note:
Be sure to correctly connect the individ-
ual leads on the mains cable (external)
7
: live
wire, black or brown = symbol L, neutral wire,
blue = symbol N, earth wire, green-yellow=
symbol
Install the lights‘ plastic cover
2
. To do this,
match the cover‘s three notches to the corre-
sponding retaining bolts
10
(see Fig. H) and
press it from the bottom up. Turn the cover
clockwise (right, following the direction of the
arrow) to fix it. The adhesive label with the
arrow
11
can now be removed.
Replace the fuse or switch on the circuit
breaker in the fuse box (I position).
Your LED ceiling light
12
with Bluetooth speaker is
now ready.
Installing the wall bracket
Install the wall bracket for the remote control
26
using the screws
25
or adhesive pads
27
as
shown in Figure I.
Inserting / replacing batteries
Note:
The remote control requires two batteries type
AAA / LR03 (included).
Slide the battery case cover (reverse) down by
approx. 1 cm to open and then lift off the cover.
Insert two batteries of the included type
AAA / LR03 in the battery compartment. Please
note the correct polarity!
Slide back the cover to close the battery
compartment.
Your remote control is ready to use.
Operating the light by switch
The LED ceiling light
12
may be switched on
and off using the wall switch. Here the bright-
ness will always be 100 %. All other functions
are solely controlled via remote control.
Using the remote control
ATTENTION!
The functions of the remote control
can only be used after switching the LED ceiling
light
12
on with the wall switch.
Switching the light on / off
1. Switching the light on
Press the “
“ button (lighting)
13
, to switch the
LED ceiling light
12
on. A beep confirms recep-
tion of the signal.
2. Switching the light off
Press the “
“ button (lighting)
14
, to switch
the LED ceiling light
12
off. A beep confirms
reception of the signal.
