8 GB
Care and cleaning / Disposal / Warranty and Service
Safety / Preparing the product for use / Care and cleaning
Styrofoam etc. can turn into dangerous toys for
children.
ATTENTION!
Do not look into the LED from a close distance
during operation.
Do not look at the LED with an optical instru-
ment (e.g. magnifier).
The illuminant in this light is not replaceable; if
the illuminant reaches the end of its services
life, replace the entire light.
Working safely
Install the light so that it is protected from
moisture and dirt.
Prepare carefully before assembly and allow
yourself enough time. Lay out all the individual
components and additional tools or materials
required so that you can see and reach them.
Remain alert at all times and always watch what
you are doing. Always proceed with caution
and do not assemble the lamp if you cannot
concentrate or feel unwell.
Preparing the product for use
Assembling the lamp
Note:
You will require a second person to help
with the assembly of the product.
Note:
Please ensure that you pull the cable during
fitting slowly through the base.
Remove the transport locks
7
from the tube
4
.
Make a loop from the mains cable and insert
the loop into the top of the tube
4
.
Connect the sections of tube
4
and screw in
place.
Note:
Be sure to screw in the section of tube
4
as far in as possible to ensure the light is stable.
Be careful not to pinch the mains cable inside
the tube
4
.
Repeat this process with all sections of the
tube
4
.
Insert the tube
4
into the base
8
and screw
in place.
Tighten the nut
9
at the underside of the
base
8
.
Note:
Be sure to hold the tube
4
tight when
tightening the nut
9
.
Note:
Be sure the cable is inside the desig-
nated opening in the base
8
and cannot be
pinched.
Position the uplight upright.
Attach the uplight head
1
to the tube
4
and
tighten the locating screw
2
with the socket
head wrench
3
to secure in place.
Plug the power plug into a socket that has
been professionally installed.
Your lamp is now ready for operation.
Switching the lamp on / off
Use the touch switch
13
to switch the uplight
on or off.
Touching the touch switch
13
repeatedly will
dim the uplight.
Use the ON/OFF switch
12
to switch the
reading lamp on and off.
Directing the lamp
CAUTION! RISK OF BURNS
DUE TO
HOT SURFACES!
First allow the lamp to cool
completely.
Bend the flexible arm
6
to bring the reading
lamp into the desired position.
Adjust the uplight head to the desired position.
Care and cleaning
RISK OF ELECTRIC SHOCK!
First pull the mains plug
11
out of the mains socket.
CAUTION! RISK OF BURNS
DUE TO
HOT SURFACES!
First allow the lamp to cool
completely.
