LIVARNO LUX 274285, Инструкции по эксплуатации и безопасности

Страница: 9 / 37

9 GB
Installation / Start-up
Notice:
If the lighting angle is not ideal, switch the light off
and allow to cool down for 15 minutes. Loosen the
adjusting screws
4
with a screwdriver and read-
just the lighting angle. Then tighten the adjusting
screws
4
.
Start-up
Note: The LED light has a motion detector
9
which responds to temperature changes.
The motion detector
9
works best in ambient tem-
peratures below 20 °. A moving object with a tem-
perature near the ambient temperature is difficult to
detect.
Note: The control dials are located below the
motion detector
9
(Fig. A).
Note: The maximum range of the motion
detector
9
is approx. 12 m, the detection radius
approx. 180 °.
Note: The horizontal directional radius of the
motion detector
9
is approx. 130 °. The vertical
directional radius of the motion detector is
approx. 90 °.
Do not adjust the motion detector
9
with
force. The safety stops could break.
Aligning the motion detector
Note: The detection area must be well within range
of the infrared beams from the motion detector
9
.
The view of the detection area must not be obstructed
by objects such as plants etc. Infrared beams cannot
pass through solid objects.
Note: The detection area should run transversely
to the direction of passage and be kept as small as
possible. A large detection area increases the risk
of the light being switched on for irrelevant reasons.
1. First align the motion detector
9
horizontally.
2. Then loosen the locking screw (motion detector)
5
by turning it counter-clockwise.
3. Now align the motion detector
9
vertically and
tighten the locking screw (motion detector)
5
clockwise.
4. Test your settings by walking slowly into the de-
tection area. Repeat steps 1 to 3 until you achieve
the desired result.
Automatic operation
Adjusting the sensor sensitivity (SENS):
Adjust the sensor sensitivity to your preferences
using the SENS rotary control
6
.
Turn clockwise to increase the sensor sensitivity.
Turn counter-clockwise to decrease the sensor
sensitivity.
Note: The further right the rotary control is turned,
the more sensitive the motion detector will be, i.e. it
will already respond to minor temperature changes
within the detection range. If the sensitivity is set too
high, even small animals or movement from leaves
(from trees or shrubs) may already trigger the motion
sensor, inadvertently activating the light.
Adjusting the on duration (TIME):
Set the light on time (5 s–10 min) using the
TIME rotary control
7
.
Turn clockwise to increase the on time. Turn
counter-clockwise to decrease the on time.
Adjusting the light sensitivity (LUX):
Set the desired light sensitivity using the LUX
rotary control
8
.
Turn clockwise to increase the light sensitivity.
The light is more sensitive to changes in light in-
tensity and switches to automatic mode sooner.
Turn counter-clockwise to decrease the light
sensitivity. The light is less sensitive to changes
in light intensity and takes longer to switch to
automatic mode.
Note: If the LUX rotary control
8
is in the po-
sition, the motion detector will work
9
day and night.
If the LUX rotary control
8
is in the position, the
motion detector
9
will only work at night.
Note: Once the light has been activated by the
motion detector
9
, it will remain on for the set time.
If new movement is detected during this time, the
original period will be extended by this set amount
of time.
Preparation / Prior to installation / Installation