Little Wonder PROVAC SI 5511-02-01, Руководство оператора и каталог запасных частей

Страница: 16 / 30

16
LITTLE
WONDER
PROVAC SI
MAINTENANCE INSTRUCTIONS
Stop engine, remove the spark plug wire and allow for
the fan to come to a complete stop before performing any
maintenance.
Keep the engine’s cooling air intake clear of debris for
best performance.
Keep all hardware tight.
Clean air cleaner daily. See engine manual for details.
Check oil level daily. Top off as needed.
After each use, run the vacuum with an empty bag to
clear any material that may remain in the housing. The
bag may also be cleaned by shaking or washing under
still or low pressure water. DO NOT use a high pressure
washer to clean the debris bag.
Check bag strap for tightness.
Change engine oil after the first 5 hours of operation.
Then change as recommended by the engine
manufacturer.
1. Remove drain plug and drain oil while engine is warm.
2. Replace drain plug, remove fill plug and fill with new
oil. Little Wonder recommends SAE 30 oil whenever
applicable.
3. Start and run engine for 30 seconds. Stop engine.
4. Wait 30 seconds, then re-check oil level.
5. Top off if necessary. See engine manual for details.
STORAGE
To prevent possible explosion or ignition of vaporized
fuel, do not store equipment with fuel in tank or
carburetor in an enclosure with open flame (for example,
a furnace or water heater pilot).
Before the equipment is put into storage for any
period exceeding 30 days, the following steps should
be completed.
1. Drain all fuel from the fuel tank and fuel lines.
2. Start the engine and run until all the fuel is used from
the carburetor float bowl and the engine stops.
3. While the engine is still warm, drain the crankcase oil
and replace with the proper weight oil corresponding
to the season the equipment will be next used.
4. Remove the spark plug and squirt a small amount of
engine oil into the cylinder. Slowly pull the starter a
few times to distribute oil in the cylinder and reinstall
the spark plug.
5. Check oil level again and top off if necessary. See
engine manual for details.
To put the equipment into service after an extended
period of storage.
1. Check for loose parts and tighten if necessary.
2. Fill the fuel tank and then check the engine oil level.
Top off if necessary. See engine manuals for details.
3. Start the engine and check for fuel leaks. Repair any
leaks before operating the unit.
MAINTENANCE / STORAGE
Before performing any type of maintenance on the
machine, stop engine, wait for all parts to stop mov-
ing and disconnect spark plug. Failure to follow this
instruction could result in personal injury or prop-
erty damage.