Little Wonder Classen TRS-20, Руководство оператора и каталог запасных частей

Страница: 8 / 18

8
GENERAL
MAINTENANCE
TO KEEP THE TRS-20/TSS-20 IN
GOOD OPERATING CONDITION,
PERFORM THE FOLLOWING:
• When replacement parts are required, use
genuine Classen parts or parts with
equivalent characteristics including type,
strength, and material. Failure to do so may
result in product malfunction and possible
injury to the operator and/or bystanders.
• Keep all safety decals legible. Remove all
grease, dirt and debris from decals. Any
safety decal that becomes illegible should
be replaced immediately (see ‘Safety
Decals” section). Safety decals can be
affixed by peeling off the backing and
applying to clear, dry surface. Smooth
out to remove any air bubbles.
• Do not operate equipment without shields
in place.
• Do not make any adjustments or perform
any maintenance while the engine is
running.
• Check engine mounting bolts frequently to
maintain proper tightness.
• Thoroughly clean off blades when
application is completed and apply a light
coat of oil to prevent rust on blades.
• Keep belt free of oil and dirt.
• Check for worn or deteriorating
components that could create a hazard.
When new components are installed, be
sure that current safety decals are affixed to
the replaced components. Safety decals can
be affixed by peeling off the backing and
applying to clear, dry surface. Smooth out
to remove any air bubbles.
ENGINE MAINTENANCE
• Refer to engine manufacturer’s
Owner’s Manual.
• Check engine oil level with engine resting
in a level position.
• Inspect air filter element and replace if
necessary.
• If carburetor adjustment is necessary, stand
to one side and keep feet and hands clear
while making adjustments.
MACHINE STORAGE
STORAGE INSTRUCTIONS
Before the TRS-20/TSS-20 is put into storage for
any period exceeding 30 days, the following steps
should be taken.
1. Drain all fuel from fuel tank and fuel lines.
2. Start engine and run until all fuel is used
from carburetor float bowl.
3. While engine is still warm, drain the
crankcase oil and replace with the proper
weight oil corresponding to the season the
TRS-20/TSS-20 will next be used (refer to
engine manufacturer’s Owner’s Manual).
4. Remove the spark plug and squirt a small
quantity of engine oil into the cylinder.
Turn the engine over a few times to
distribute that oil.
OPERATION AFTER EXTENDED
STORAGE
To put TRS-20/TSS-20 into operation after an
extended storage:
1. Check for loose parts and tighten
if necessary.
2. Check for cracked or broken blades
and replace,
3. Check that all safety decals are in place
and legible.
4. Fill fuel tank.
5. Check engine oil level with engine in level
position (refer to engine manufacturer’s
Owner’s Manual).
6. Start engine.
7. Check for fuel leaks.
SAFETY WARNING
TO PREVENT POSSIBLE EXPLOSION OR IGNITION
OF VAPORIZED FUEL, DO NOT STORE EQUIPMENT
WITH FUEL IN TANK OR CARBURETOR OR NEAR
OPEN FLAME (I.E. FURNACE, WATER HEATER,
PILOT LIGHT).