Form 995271 — 06/2004
www.LittleGiantPump.com
HWAB – Indoor High Water Alarm
General Installation Instructions:
1. Determine indoor mounting location and insert screw in
desired location.
2. Hang alarm using keyhole on back of enclosure. Install
second screw in mounting flange at bottom of alarm.
3. Make sure power is disconnected.
4. Place the float switch cord into the clamp as shown in
Figure A.
5. Locate float at desired activation level and secure to the
discharge pipe as shown in Figure A. NOTE: do not install
cord under clamp band or over-tighten clamp band.
6. Make sure excess clamp band does not interfere with float
operation
7. Connect float switch cable to alarm according to Figure B.
8. Install 9 VDC for backup alarm function.
9. Plug the alarm power cord to primary power and verify the
green “power on” light is illuminated.
10. Use the provided cable clasp and secure the power cord
to the outlet as shown in Figure C. Use existing receptacle
faceplate screw and supplied washer.
11. Check installation by raising the alarm float. The horn will
sound and the “alarm” light will illuminate.
Figure A.
Figure B.
Figure C.
NOTE: Little Giant Pump Company cannot be responsible for damages
caused by faulty or negligent installation of this control. We recommend
that you engage the services of a competent plumber, electrician, or quali-
fied service person to install this product in accordance with national and
local electrical codes.
Item
Number
Model
Number
Primary
Voltage
Secondary
Voltage
513288
HWAB
120V, 60 Hz
9VDC
PO Box 12010 • Oklahoma City, OK 73157
Phone: 800.701.7894 • Fax: 800.701.8046
E-mail: [email protected]