LIMITATIONS, AND POTENTIAL HAZARDS. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!
SAFETY GUIDELINES
SHUT OFF ELECTRICAL POWER AT FUSE- OR BREAKER- BOX BEFORE ATTEMPTING TO SERVICE, DISCONNECT CONNECTOR,
OR REMOVE ANY COMPONENT!
1.
Do not use to pump flammable or explosive fluids such as gasoline, fuel oil, kerosene, etc. Do not use in explosive
atmospheres.
2.
Do not handle unit with wet hands or when standing on wet or damp surface or in water.
3.
In any installation where property damage and/or personal injury might result from an inoperative or leaking
pump due to power outages, discharge line blockage, or any reason, a backup system(s) and/or alarm should be
used.
4.
Support pump and piping/tubing when assembling and when installed. Failure to do so may cause piping/tubing
to break, become disconnected from pump and/or cause pump to fail or not operate correctly, etc.
5.
The control unit/pump is not submersible and must be installed so that water cannot be dripped, splashed
or sprayed onto the control unit/pump.
6.
If the supplied power cord is missing or damaged, it must be replaced with a special cord available from the
manufacturer or its service representative.
7.
For proper automatic operation, the reservoir must be positioned level and horizontal. Do not operate the
pump with the filter screen removed.
8.
Do not run this pump dry.