PWM Series Wet Rotor Water Garden Pump
OWNER'S MANUAL
English
EN
The PWM Series pump are designed for high-flow applications. They are dura
-
ble and reliable for many water gardening applications, especially waterfalls.
They are energy efficient, using up to 60% less electricity than direct drive
pumps.
The pump does not use seals, and it does not contain oil. All electrical compo
-
nents, including the motor, are completely sealed in a non-toxic, plastic resin.
The pump can be installed in-line by removing the bottom screen. It is
equipped with a 20 ft (6.1 m) power cord.
This product is covered by a Limited Warranty for a period of 1 year from the
date of original purchase by the consumer. For complete warranty information,
refer to
www.LittleGiant.com
or call Technical Support for a printed copy.
Specifications
SAFETY INSTRUCTIONS
This equipment should be installed and serviced by technically qualified personnel who are familiar with
the correct selection and use of appropriate tools, equipment, and procedures. Failure to comply with
national and local electrical and plumbing codes and within Little Giant recommendations may result in
electrical shock or fire hazard, unsatisfactory performance, or equipment failure.
Know the product’s application, limitations, and potential hazards. Read and follow instructions carefully to
avoid injury and property damage. Do not disassemble or repair unit unless described in this manual.
Failure to follow installation or operation procedures and all applicable codes may result in the following
hazards:
Model
Item Number Amps Watts
Discharge
Suction
Max Height
PWM2600
517250
1.8
155
1 - 1/2" FNPT
(3.8 cm)
1 - 1/2" MNPT
(3.8 cm)
10.0 ft (3.0 m)
PWM3900
517251
2.4
280
12.7 ft (3.9 m)
PWM5200
517252
5.0
410
20.0 ft (6.1 m)
Risk of death, personal injury, or property damage due to explosion,
fire, or electric shock.
• Do not use to pump flammable, combustible, or explosive fluids such as gasoline, fuel oil, kerosene,
etc.
• Do not use in explosive atmospheres or hazardous locations as classified by the NEC, ANSI/NFPA70.
• Do not handle a pump or pump motor with wet hands or when standing on a wet or damp surface,
or in water.
• When a pump is in its application, do not touch the motor, pipes, or water until the unit is unplugged
or electrically disconnected.
