VAP
Installation Instructions
Lithonia Lighting
INDUSTRIAL VALUE STREAM
One Lithonia Way, Conyers, GA 30012
Phone: 800-315-4963 Fax: 770-981-8141
www.lithonia.com
Revision Date: 03/2010
Part Number: U21316
VAP JUNCTION BOX SNAP BRACKET (JMB) INSTALLATION
INSTRUCTIONS
Fig 9
Fig 10
Fig 11
1. Attach JSB bracket (Fig 9) to junction box.(hardware provided by others).
Remove protective film from gasket (included with JSB) and attach adhesive side
to the JSB.
2. If field installing, remove diffuser, lamps and channel cover. Using a 7/8” hole
saw drill out access hole in the center of the fixture housing for electrical connec-
tion. Remove KO from channel.
3. If field installing the JMB bracket mounting, attach two (2) brackets to fixture
housing as shown in Fig 10 (maximum 25 inch-pounds torque on screws).
4. Attach on side of fixture bracket to JSB, rotate fixture up until it snaps into the
JSB. Secure JSB to fixture using the screw provided (Fig 11).
5. Make electrical connections and re-install the channel cover, lamps and
diffuser.
VAP MOTION SENSOR INSTALLATION INSTRUCTIONS
1. Install wet location fitting in end of fixture.
2. Thread extension adapter for sensor into the wet
location fitting.
3. Wire sensor into the fixture as shown in Fig 12.
Fig 12
