RJ5210155
01/06
Glass Lens Change
Tools Needed: 1/2" wrench (For convenience, the lens is interchangable from a flat full cutoff lens to a contoured drop lens or drop lens to flat lens)
1. Open the doorframe assembly, loosen the (4) lens clips securing nuts using a 1/2" wrench and remove them from the studs being careful to keep
the lens from falling or being damaged.
2. Take the existing lens gasket and place on new lens, place lens in doorframe assembly and re-apply the (4) lens securing clips and their (4) nuts securing well. (Do not
secure to the point of bending the clips)
Note: The optical reflectors are SPECIFICALLY designed for their respective lens option. We can not accept responsibility for photometric performance when these
are not matched.
KVFEHS External Houseside shield
Tools Required: Drill, 5/32" drill bit, phillips type screwdriver, slotted screwdriver
The KVF EHS is unique and aesthetically pleasing design that can be rotated to any desired side needed to help eliminate unwanted spill light.
1. Choose the side needed to apply the shield. Align the shield in this position and choose the four indicator dimples that need to be drilled out, mark or remember
which dimples will be drilled.
2. Setting shield aside, open doorframe in order to keep drill from penetrating reflector. Drill the indicator dimples chosen with 5/32" drill bit, being careful not
to penetrate the lens gasket by keeping drill perpendicular to the doorframe.
3. Close the doorframe and secure it. Align shield with chosen drilled holes, install the 4 screws provided with phillips type screwdrive.
Optical Rotation
(This fixture is designed with optical rotation ease in mind via tool-less design)
1. Open door assembly. Gently pry or pull reflector away from housing. Rotate optical assembly to desired light output as indicated by light distribution arrow on reflector.
Insert reflector assembly back into housing being sure to line up the four pop balls and their receptacles.
2. Check to make sure the reflector is seated properly and secure before installing lamp and closing door assembly.
ASY Reflector:
Drop Lens: Paint on lens should be positioned toward the pole.
Flat Lens: Paint on Reflector should be positioned toward the parking lot.
