Figure A
Single Face Exit
Single Lamp 277 volt wiring
PARTS DESCRIPTION
a
Charger PC Board
b
Self-Diagnostics PC Board
c
Pushnut Connectors
d
Battery
e
Battery Connector
f
Lamp Connector Cable
g
Self-Diagnostics Harness (to Test Switch/
Status Indicator connector)
h
Self-Diagnostics Harness (to Charger PCB)
i
Lampboard
j
Manual Test Switch
k
Test Switch/Status Indicator Connector
l
Magnetic Test Switch
m
Lamp Connector
n
Charger Board/Self-Diagnostics Connections
Page 2
SINGLE FACE EXIT
INSTALLATION:
1. Refer to main Installation Instructions manual for all
installation, mounting, cleaning instructions and additional
figures detailing unit.
Important Note: Care should be taken to disconnect both
the test switch/status indicator connector
k
, and the lampboard
connector
m
before removing the lampboard
i
from the unit.
WIRING:
Note: Select appropriate wiring diagram for input voltage to be
used.
Important Notes:
1. This equipment to be connected to an unswitched circuit
only.
2. Cap all unused leads separately.
3. Canopy mount exits have polarized connectors on A.C.
installation wire leads and option installation wire leads.
4. CAUTION: Damage to battery will occur if battery connec-
tor is connected to charger board for a prolonged period of
time without continuous A.C. power provided.
Single Lamp 120 volt wiring