Supreme Leader v1.0
Manufacturers and product names are mentioned solely for circuit identification, and where applicable their trademarks are the
property of their respective owners who are in no way associated or affiliated with the author. No cooperation or endorsement
is implied.
8
Modifications
Boost (foot)switch
On the original pedal
SW1
only has 2 boost positions (on and off). On this PCB
SW1
is by default a
3PDT (On-Off-On) switch soldered on the PCB and so giving you 3 options: High boost, no boost and a
custom boost. As you can see left and middle position are as in the original (on and off). The right
position enables you to create a custom boost level determined by
R11
and
R24
. By default
these are
6k8 resistors, creating a 2/3 level boost. You can change these values in the range between 6k8 and
15k. 15k will create ½ level boost.
If you only want 2 boost options as in the original, then leave out
R11
,
R24
and use a standard DPDT
(On-On) for
SW1
.
SW1
can also be foot switchable. For this leave out
R11
and
R24
and use a standard 3PDT footswitch.
To make it a bit easier, there are 3 special pads attached to
SW1
on the PCB:
Remember that all 3 middle lugs on the switch must be soldered together by that single wire! As
there is only one LED+ pad, you can solder the Anode of the LED directly to the + side of the DC jack
as depicted above.
Boost
Cathode (short leg)
Anode (long leg)
R led
Ring
Sleeve
Tip
Содержание Supreme Leader
Страница 1: ...Supreme Leader Building instructions v1 0 ...