OmniRat v1.0
Manufacturers and product names are mentioned solely for circuit identification, and where applicable their trademarks are the
property of their respective owners who are in no way associated or affiliated with the author. No cooperation or endorsement
is implied.
8
Drill instructions
17,8mm
Volume
Distortion
Tone/Filter
17,8mm
17,8mm
Holes for the potentiometers should be
7mm
.
Troubleshooting
All PCB’s have been
100% factory e-tested and out of every batch I receive I build an effect to double
check, so there should not be a connection problem on the PCB itself.
The board is not working (at all), what now?
•
Check if your 9V is plugged in correctly (and/or soldered correctly on the board). Pay special
attention to the polarity.
•
Check that you oriented
the capacitors, IC’s ,transistors and diodes the right way.
SMF, MKT
and ceramic capacitors as well as resistors do not need to be oriented. A likely sign of
incorrect capacitors and/or orientation is when an effect is sputtering, rumbling or
“motorboating”.
•
Check if you used the correct values of the components. For resistors you can look here:
http://www.diyaudioandvideo.com/Electronics/Color/
•
Double and triple check your soldering! A loose or cold solder can be really bad for your
board.
•
Replace the IC and/or transistors, one might be defective. Before doing that first unplug the
9V and wait for 5 seconds.
•
Check that you have good/high grade components. A lot of Chinese sourced parts are fakes
(especially high end opamps, audio capacitors, vintage diodes and transistors) so be careful
that you source your parts from reliable suppliers.
Содержание OmniRat
Страница 1: ...OmniRat Building instructions v1 0 ...