Lithium Grim Divine Fuzz, Инструкция по сборке

Страница: 5 / 7

5
Off board wiring
Tip
Tip
Ring
Output Jack
Input Jack
Cathode (short leg)
Anode (long leg)
Footswitch
S
Sleeve
R led
Ring
R led
NB. If you do not want to use the D1 diode than remember to short it by soldering a lead instead.
NB 2. You are free to use any ground connection you want on the PCB (GND) if the sequence as
mentioned in the picture above does not match your build.
Notice that in the “off” position the effect input is connected to ground to prevent possible
oscillation.
The LED requires a resistor (R led in the diagram) depending on the type of LED you are using. An
ultra-bright red or blue LED requires a 4k7 resistor, Green requires 680R.
Blue = pin 1
White = pin 2
Yellow = pin 3