Lithium Grim Cabulator, Инструкция по сборке

Страница: 6 / 15

Cabulator v1.0
Manufacturers and product names are mentioned solely for circuit identification, and where applicable their trademarks are the
property of their respective owners who are in no way associated or affiliated with the author. No cooperation or endorsement
is implied.
6
Besides the components mentioned in the components table, you will need:
•
1 mono input jack, 1 stereo output jack .
•
3PDT footswitch (9 pins)
•
2,1mm DC jack (isolated).
•
22 gage stranded hook-up wire.
•
LED holder. This enables you to mount the LEDs in the enclosure.
•
LED (3mm or 5mm depending on your taste). This will be the status LEDs
•
Hammond 1590BB case (or similar) in your favorite color. This case will fit tightly and leaves
no room for error! If you need more room you could consider using a Hammond 1590XX .
Drill template
29,6 mm 29,6 mm
Resonance Cabsize
High
Response
42,8mm
Footswitch
15mm
29,6 mm 29,6 mm
Gain
Punch
Mid
Response
27,8mm
After drilling the holes, insert the potentiometers in the enclosure and then insert them in the back
of the PCB.
You can break off the pin I marked with the yellow circle with a small
pair of pliers. The rectangle pad marks the pad for
pin 1 .
If all fits well you can solder the potentiometers to the board.
Pots drill holes 7mm
Switch drill holes 6mm
Footswitch drill hole 13 mm