MAINTE
Use this grip
thumb below
handle
Figure A: Holding the Chain Saw
b.
Do not overreach and do not cut above
shoulder height.
This helps prevent
unintended tip contact and enables better
control of the chain saw in unexpected
situations.
c.
Only use replacement bars and
chains specified by the manufacturer.
Incorrect replacement bars and chains may
cause chain breakage and/or kickback.
d.
Follow the manufacturer’s sharpening and
maintenance instructions for thesawchain.
Decreasing the depth gauge height
can lead to increased kickback.
15. Maintain labels and nameplates on the tool.
These carry important safety information.
If unreadable or missing, contact Litheli
for a replacement.
16. Avoid unintentional starting. Prepare to begin
work before turning on the tool.
17. Do not leave the tool unattended when the
Battery Pack is connected. Turn off the tool,
and remove the Battery Pack before leaving.
18.
The battery Charger gets hot during
use. The Charger’s heat can build up
to unsafe levels and create a fire hazard
if it does not receive adequate
Especially avoid placing the Charger on
carpets and rugs; they are not only flammable,
but they also obstruct vents under the Charger.
Place the Charger on a stable, solid,
nonflammable surface (such as a stable metal
workbench or concretefloor) at least 1 foot away
from all flammable objects, such as drapes or
walls. Keep a fire extinguisher and a smoke
detector in the area. Frequently monitor the
Charger and Battery Pack while charging.
19. This product is not a toy.
Keep it out of reach of children.
20. The warnings, precautions, and instructions
discussed in this instruction manual cannot
cover all possible conditions and situations that
may occur. It must be understood by the
operator that common sense and caution are
factors which cannot be built into this product,
but must be supplied by the operator.
Lithium Battery Safety Warnings
LITHIUM BATTERIES STORE
A LARGE AMOUNT OF ENERGY AND
WILL VENT FIRE OR EXPLODE IF MISTREATED:
1. Keep Battery
Pack dry.
2. DO NOT DO ANY OF THE FOLLOWING
TO THE BATTERY PACK:
a. Open,
b. Drop,
c. Short-circuit,
d. Puncture,
e. Incinerate,
.
F
°
4
0
1
n
a
h
t
r
e
t
a
e
r
g
s
e
r
u
t
a
r
e
p
m
e
t
o
t
e
s
o
p
x
E
.
f
3. Charge Battery Pack only according
to its Charger’s instructions.
4. Inspect Battery Pack before every use;
do not use or charge if damaged.
ventilation, due to an electrical fault, or if it is
used in a hot environment. Do not place the
Charger on a flammable surface. Donot
obstruct any vents on the Charger.
Page 5
U1CS27042
WWW.LITHELI.COM