page 4
5. Fan Assembly.
If you wish to extend the hanging length of your
fan, you must remove the hanging ball from the
6in. downrod provided to use with an extended
downrod (sold separately). [
If you wish to use the
6in. downrod, please proceed to instructions
following the dotted line below.
]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove
stop pin. Slide hanging ball off the original
downrod, A, and slide it down the longer
downrod, B (the top of the downrod should be
noted as having a set screw hole; use this hole
when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging
ball. Be sure stop pin aligns with slots on the
inside of the hanging ball. Tighten set screw
securely.
set screw hole
set screw
hanging ball
stop pin
A
B
NOTE
: The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common
sense and caution are necessary factors in the
installation and operation of this fan.
["Fan Assembly" continued on next page.]
Slide downrod through canopy and yoke cover.
Thread electrical wires through downrod and
pull extra wire slack from the upper end of the
downrod.
Tip
: Apply small piece of electrical tape to the
ends of the electrical wires to keep them
together when threading them through the
downrod.
Loosen yoke set screws and nuts and remove pin
and clip from motor housing yoke. Place
downrod into the motor housing yoke and re-
insert pin and clip. Tighten yoke set screws and
nuts securely.
yoke set screw
downrod
electrical wiring
clip
canopy
motor
housing
yoke cover
pin