Litex Industries WE52BNK5LR Скачать руководство пользователя страница 9

page  8

       CAUTION: “DO NOT DISPOSE OF BATTERIES IN FIRE, BATTERIES MAY EXPLODE OR LEAK.” - When disposing of 
household alkaline batteries, it is best to check with your local and state recycling or household hazardous waste 
coordinators concerning the specifics of the program in your area. You may also locate a recycling center by calling 
1-800-8-BATTERY or 1-877-2-RECYCLE or visit www.epa.gov/epawaste/index.htm or www.earth911.org for more 
information.

Restore electrical power.  Within 30 seconds of restoring the power, press 
and hold the "O" button  on the remote control transmitter for 5 seconds 
or until light on fan blinks twice. Test the light and fan functions to 
confirm the learning process is complete.

NOTE

: Remove protective covering from front of remote control 

transmitter and discard.

IMPORTANT

: To prevent damage to transmitter, remove the battery if not 

used for long periods.  Store the remote control transmitter away from 
excess heat or humidity.

Operation buttons on the panel of the remote control transmitter:

3 button 

 

     for 

fan

 

HIGH

 speed

2 button 

 

     for f

an

 

MEDIUM

 speed

1 button 

 

     for 

fan

 

LOW

 speed

0 button 

      

     to turn 

fan

 

OFF

    button     

 

     to turn l

ight

 

ON

 or 

OFF

Tap      button quickly to turn lights off or on. Hold      button down to 
increase or decrease lights. If you press      button in excess of 0.7 seconds, 
it becomes a dimmer. The lights vary cyclically in 8 seconds. The light 
button has an auto resume function, which keeps the light at the same 
brightness as the last time it was turned off.

(back side)

Battery Cover

Remote Control
Transmitter

Battery

11. Remote Control Operation.

If you wish to use the remote control bracket, install 
screws, included in remote pack, through bracket and 
into the desired installation site. The remote control 
transmitter rests inside the bracket.
 

CAUTION

: The remote control transmitter can be 

programmed to multiple receivers or fans. If this is not 
desired, turn wall switch off to any other programmable 
receiver or fan.

Remove battery cover from back of remote control 
transmitter.  Install battery (included) with positive (+) 
end toward top of remote control transmitter. Replace 
battery cover.

          

WARNING: 

Choking Hazard - Small parts. 

           Keep battery away from children.

Remote Control
Bracket

Wall

Bracket
Screws

Содержание WE52BNK5LR












Отзывы: