page 9
11. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Restore power from
circuit box and light switch (if applicable).
Test fan speeds with the pull chain on the
switch housing. Start at the OFF position (no
blade movement). First pull will set the fan to
HI. Second pull will set the fan to MEDIUM.
Third pull will set the fan to LOW. Fourth pull
will again set the fan to the OFF setting. Test
light with the pull chain in the middle. (
Refer
to
diagram 1
.
) If fan and/or light do (does)
not function, please refer to
"Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off
before
moving the
reverse switch. Set reverse switch to
recirculate air depending on the season:
- DOWN position in summer (
diagram 2
)
- UP position in winter (
diagram 3
)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower
your thermostat setting in winter without
feeling a difference in your comfort.
Important
: Reverse switch must be set either
completely UP
or
completely DOWN
for fan to
function. If the reverse switch is set in the
middle
position (
diagram 4
), fan will not
operate.
Attach pull chain extension(s) supplied or
custom pull chain extension(s) (sold
separately) to end(s) of the pull chain(s).
diagram 2
diagram 3
diagram 4
diagram 1
switch housing
fan pull chain
light pull chain
reverse switch
