8. Blade Assembly.
7. Canopy Assembly.
page 6
blade
blade arm
canopy set screw
canopy
motor
housing
Time Saver
: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 16 blade attachment screws and
washers and 16 decorative nuts in one of the
hardware packs. Align holes in blade with holes
in blade arm. (
Note label on blade arm indicating
THIS SIDE UP.
) Push decorative nuts through
from underside and insert blade attachment
screws (along with washers) from topside.
Tighten all 4 screws securely.
Repeat procedure
with remaining blades.
Locate 1 rubber cushion at the top of the motor
housing. Remove the 2 larger screws (
do
not
remove center screw
) and washers but leave
rubber cushion intact.
Lower blade arm over rubber cushion and
attach with screws and washers that were
previously removed. Tighten screws securely.
Repeat with the remaining blades.
NOTE
: Tighten blade arm screws twice a year.
decorative nuts
Raise canopy to hanging bracket until canopy
touches the ceiling. Tighten the canopy set
screw to secure canopy.
Carefully remove protective paper from
downrod.
downrod
